Intended Use; Safety Instructions - Conrad 55 24 45 Bedienungsanleitung

O P E R A T I N G I N S T R U C T I O N S
Adapter Plug
with motion detector
Item no. 55 24 45

Intended use

Using the product, a consumer that is connected to it can be activated by means of a PIR
motion detector.
The adapter plug must be connected to an earthed mains socket; the mains voltage must be
230 V/AC, 50 Hz.
A consumer, with a power consumption of up to 3680 W, can be connected to the socket on
the adapter plug.
The product may only be used in dry, enclosed spaces.
Always observe the safety instructions included in these operating instructions. Read the oper-
ating manual carefully, keep it in a safe place and pass it on to other users, when appropriate.
Any use, other than the one described above, may damage the product. Moreover, this involves
hazards such as e.g. short circuit, fi re, electric shock, etc. It is not allowed to modify or rebuild
any part of the product!
This product complies with the applicable national and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Explanation of Symbols, Inscriptions
This symbol indicates a health hazard, e.g. electric shock.
The exclamation mark indicates specifi c risks associated with handling, function and
use.
☞
The "Hand" symbol indicates special tips and operating information.
The product is only intended to be placed and used in dry, enclosed indoor areas; it
must not get damp or wet.
Contents
• Adapter Plug
• Operating Instructions

Safety Instructions

The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any consequen-
tial damage!
Nor do we assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! The warranty
will be void in such cases!
a) General instructions
• The unauthorised conversion and/or modifi cation of the product is not permitted for
safety and approval reasons (CE). Do not open/disassemble!
• The device is designed according to safety class I. It may only be used when con-
nected to an earthed mains socket.
• The adapter plug is equipped with a child safety device. Only when the
prongs of a power plug are placed in both openings of the socket at the same time
will the mechanism release the opening.
Even so, be especially careful if children are around. Children cannot see the
dangers arising from the incorrect use of electrical devices. There is a risk of a
life-threatening electric shock!
The product is not a toy and must be kept out of the reach of children. Position the
product so it is out of the reach of children.
• Do not carelessly leave the packaging material lying around since this may
become a dangerous toy for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental
drops, even from a low height.
www.conrad.com
Version 07/12
b) Operating location
• The product may only be used in dry, enclosed, indoor areas, it must not get damp or
wet! Never position the product in the direct vicinity of a bathtub, shower, bathroom,
swimming pool, or similar. Danger to life from electric shock!
• The product must not be exposed to extremes of temperature, direct sunlight or
strong vibrations.
• Do not operate the device in environments where there are high levels of dust,
fl ammable gases, vapours or solvents. There is a danger of fi re and explosion!
c) Handling and Use
• Never plug in or unplug the product with damp or wet hands. There is a risk of a
life-threatening electric shock! The same applies for the plug that is plugged into
the product's socket.
• Never connect the product to the power supply immediately after it has been trans-
ferred from a cold room into a warm one (e.g. during transport). The condensation
that develops in such cases could damage the device or cause an electric shock!
Allow the product to reach room temperature. Wait until the condensation has
evaporated. This might take several hours. Only after this should the product be
plugged in to the mains socket and put into use.
• Always unplug that mains plug from the socket of the adapter using the gripping
area intended for this purpose. Never unplug a mains plug from the socket by pull-
ing on the cable!
• Never overload the product. Observe the maximum connected load in the chapter
"Technical Data".
• Do not connect in series! This can lead to overloading of the adapter plug! Fire
hazard!
• Do not operate while covered! At higher connected loads, the adapter plug be-
comes hot, which could lead to overheating and, potentially, a fi re if it is covered!
• Only voltage-free, when the plug is unplugged!
• Do not use the product if it is damaged. There is a risk of a life-threatening electric
shock!
In this case, dispose of the product in an environmentally correct manner.
A safe operation can no longer be assumed, if:
- the product shows visible signs of damage,
- the product does not work at all or works poorly (leaking smoke or a smell of
burning, audible cracking noises, discolouration to the product or the adjacent
surfaces)
- the product was stored under unfavourable conditions
- it was exposed to heavy loads during transport
• Always unplug the product from the mains socket before cleaning it or when it is
not to be used for a while.
• Never pour any liquids above or next to the product. It can cause fi re or perilous
electric shock danger. If any liquid, even so, enters the device, immediately turn off
the power supply to the mains socket where the product is connected (turn off the
fuse / circuit breaker / residual current operated circuit breaker for the associated
circuit). Only then can you unplug the plug adapter from the mains socket and
contact a specialist. Do not use the product anymore.
• In commercial institutions, the accident prevention regulations of the employer's
liability insurance association for electrical systems and operating facilities are to
be observed!
• Only use the product in a temperate climate, never in a tropical climate.
• If you have any questions that are not answered in this manual, please contact our
technical service or another specialist.