Care And Maintenance; Accessories - Rothenberger Rodiadrill 160 Bedienungsanleitung

 Apply the diamond drill bit and continue to drill using light, consistent follow-up pressure.
 Occasionally with draw the drill bit slightly from the bore so that the drilling mud or dust is
removed.
 Shut down the motor once the desired drilling depth has been achieved and pull the drilling
bit out of the borehole slowly
 Shut down the vacuum cleaner.
Removal of the drilling core on through borings
Please take precautions to prevent physical injuries or property damage.
 Allow the drilling core to fall out of the bit.
If the core should jam in the bit, use a rod to push it out from the rear.
Avoid damage to the ground.
On no account use a hammer or spanner to hit the outside of the drill bit in order
to release the core. This could deform the pipe and it would then definitely no
longer be possible to remove the drilling core from the bit.
Removal of the drilling core from tapped blind holes
 Use a screwdriver, chisel or similar tools to penetrate the annular gap that has emerged and
break and remove the core by means of a brief, forceful lateral jerk or hammer blow.
The deeper the borehole, the easier it is to break the cores. Thus, optimal results are achieved if
the borehole depth is at least the same as the diameter of the drill bit.
5

Care and Maintenance

In order to avoid damage to the equipment and guarantee trouble-free work, all parts must be
cleaned and lubricated regularly.
Rub off the equipment after every drilling job and blow out using compressed air.
If it is foreseeable that the equipment will not be used for a longer period of time, remove the drill
bit from the motor. If this is not observed, the drill bit and motor shaft can be corroded together in
unfavourable circumstances. It would be very difficult to separate both parts, causing damage.
The following work should be carried out on a weekly basis at least. Carry out on an appropriate-
ly more frequent basis in the case of more intensive work.
– Check and replace carbon brushes if necessary approximately every 250 operating
– use a fine brush to clean the collector cavity.
Important! All maintenance, overhauling and repair work must only be carried out by trained
specialised staff.
6

Accessories

Accessory Name
Extraction Rotor 1.1/4" UNC
Extraction Rotor M 30 x 2
Copper Ring 1.1/4"
Centering Pin for extraction rotor 300 mm
Centering Pin for extraction rotor 400 mm
G 1/2" ext. thread onto 1.1/4" UNC ext. thread
1.1/4" UNC int. thread onto G 1/2" int. thread
RODIA DRY CLEANER 1200
RODIA CLEANER 1400
ROTHENBERGER Part Number
FF40056
FF40057
FF35190
FF03300
FF03301
FF35080
FF35095
FF35148
FF35210
ENGLISH 17