Inserting The Batteries - Carrera RC 370142026 Ford F -150 Raptor, 370142027 Ford F-150 Raptor, 370142028 Red Hunter 2, 370142029 Inferno Orange 2, 370142032 Ford F- Montage- Und Betriebs-Anleitung

Installing the rechargeable battery
3 Using a screwdriver, remove the cover of
the battery compartment in the Carrera RC car.
Connect the end of the cable from the Carrera
RC vehicle with the charged battery. Put the
battery in place. Replace the compartment
cover using a screwdriver.

Inserting the batteries

4 Open the battery compartment with a
screwdriver and insert the batteries in the re-
mote control. Please keep in mind the correct
polarity. Different types of batteries or new
and used batteries are not to be mixed. After
having closed the compartment you can
check all functions of the remote control with
the help of the power-switch on the front. With
the power-switch turned ON and proper func-
tioning, the top center LED on the remote
control will light up red.
Now you can drive the car
Bonding vehicle and controller
5 The Carrera RC car and the remote con-
trol are bound as a factory setting.
6 1. Switch the car ON at the ON/OFF
switch. The LED on top of the car will flash
rhythmically.
7 2. Switch on the controller. The LED on
top of the controller will flash rhythmically.
After a few seconds, the LEDs on the car and
on the controller will light continuously, mean-
ing the bind has been made.
Adjusting the steering
8 If when using the Carrera RC vehicle, it starts
to pull to right or left, it can be corrected to run
straight as follows.
• Bond vehicle and controller as described in
section .
5 6 7
• Slide the ON/OFF switch fully to the right to
the position "TRIM". Adjusting mode is ac-
tive as soon as the controller LED flashes.
ENGLISH
• Straight running can be adjusted with the
right joystick.
• Slide the ON/OFF switch back to the posi-
tion "ON".
Let's practise!
9 Warning! This vehicle reaches speeds
up to 18 - 20 km/h (11 - 13 mph). Practice on
an empty surface at least 2.5 metres (8.2')
square. When first starting, be very careful
when operating the gas pedal.
10 Now it's time to practise! Set up a Carrera
RC vehicle racing track in a large empty area,
using cornerposts, empty cans, or similar ob-
jects. The basic technique to adopt when oper-
ating a Carrera RC is to drive fast on the straight
sections and to slow down in the curves.
• When changing from the first battery to
the second battery, you must stop run-
ning for at least ten minutes. At the next
change, a pause of at least 20 minutes is
absolutely essential.
• Avoid constant motor operation.
• If the car switches itself off several times
one after another, the battery is dead.
Please recharge the battery.
• Within approx. 30 minutes of inactivity,
the controller and vehicle switch off au-
tomatically. To restart, switch the ON/
OFF switch on the controller & the car to
OFF and then back to ON.
• To switch off after use, follow the steps
in the reverse order.
• After use, remove or disconnect the bat-
tery. Always recharge the battery after
use to prevent its becoming deep dis-
charged. After use, the battery must be
allowed to cool down for at least 20 min-
utes before it can be fully recharged.
• Always keep the rechargeable battery
stored outside the vehicle.
• Clean the Carrera RC car after use.
10