Warranty And Liability; Declaration Of Conformity; Environmental Protection, Disposal - Fein KBC35 Bedienungsanleitung

OBJ_BUCH-0000000288-001.book Page 21 Monday, September 4, 2017 2:16 PM
Error message/
Response of Magnet Button
Indicator lights up red for
1 second
Indicator flashes red 3 x
Indicator lights up red con-
tinuously
Indicator flashes red con-
tinuously
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
Renew stickers and warning indications on the power
tool when aged and worn.
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available through
the FEIN customer service centre.
The current spare parts list for this power tool can be
found in the Internet at www.fein.com.
Use only original spare parts.
If required, you can change the following parts yourself:
Application tools, cooling-lubricant tank

Warranty and liability.

The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
Instruction Manual.

Declaration of conformity.

FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-DB_IA,
D-73529 Schwäbisch Gmünd

Environmental protection, disposal.

Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.
Meaning
– Motion sensor has actuated
– Overload shut-off has actuated
– Incorrect mains voltage
No speed signal
– Incorrect mains voltage/mains fre-
quency
– Drill stand is overheated
– Button is blocked when switching on
Power tool is defective.
Corrective Action
After malfunction correction, the power tool
can be switched on again.
If the error occurs frequently, send the
machine to your FEIN customer service
agent.
After malfunction correction, the power tool
can be switched on again.
If the error occurs frequently, send the
machine to your FEIN customer service
agent.
Send the machine to your FEIN customer
service agent.
en
21