Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. Transporting, storing the device
•
Switch off the device (See „Switching the device on, off)
•
Allow the device to cool down completely
•
Unplug the power supply cable from the device
•
If necessary clean the device (See „Cleaning the device")
•
Lay the device and all disassembled elements into the original article packa
ging box and transport of store as specified in the technical specifications.
See technical specifications.
10.
Troubleshooting
Problem
Possible cause
Power cord is not plugged
Device is
in or not properly inserted
switched on,
but shows no
Micro-USB plug is not
function
plugged into the socket
Power cord is not plugged
in or not properly inserted
Device is switched
on, blue status LED
Micro-USB plug is not
does not shine
plugged into the socket
Device is defective
Device is switched off
LED bulbs do not
Brightness level too low
light up
Device is defective
24
Remedy
Connect power cable and
power supply correctly
Connect micro USB plug
correctly to the micro USB
socket of the device
Connect power cable and
power supply correctly
Connect micro USB plug
correctly to the micro USB
socket of the device
Contact our service!
Turn on the device
Increase the power level with
the dimming controller
Contact our service!
11. Maintaining the device and cleaning
WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
Cleaning
WARNING
Danger of electric shock
■ Do not bring the device into contact with moisture or water.
■ Always pull out the power supply plug before starting to clean the device.
Device
Cleaning
Housing
Use a microfiber cloth to remove light and stubborn dirt.
Illuminant
Clean off dirt with a dust brush or a dry, soft cloth
12.Accessories and options
You find the best accessories for your device in our web shop: www.foto-walser.de.
13. Waste disposal and protection of the environment
Dispose of the device at a legally specified collection point, such as with the
manufacturer, electronics brands or at a local disposal depot. This service is free
of charge.
14. Reference to the Declaration of Conformity
"WALSER GmbH & Co. KG. hereby declares that the remote control and integrated
radio receiver are compliant with the general requirements and all other applicable
regulations of the directive 2014/53/EU". The Declaration of Conformity is available
from the following address: info@walser.de.
25
Werbung
Inhaltsverzeichnis
