Sachtler Cine 30 HD Benutzerinformation Seite 12

Cine 30 HD
Attach the camera plate around the camera´s centre of
gravity.
Á Turn the counterbalance knob to position 9.
Á The springs of the counterbalance engage automatical-
ly by tilting the camera through the horizontal position
(audible clicking).
Á Apply horizontal brake and release vertical brake.
Á Lock the head with the tilt safety lock.
The blocking and clicking into position of the tilt safety
lock is achieved by pulling out the red knob and turning
it 90°. Green marking on the red knob becomes invisi-
ble. Make sure that the tilt safety lock has engaged.
(The head can't be tilted any more.)
Á Place the camera plate´s dovetail in the dovetail´s gui-
ding on the head (see pic. 3).
Á Lower the camera (plate). The snap lock will spring
back and snap in to secure the camera plate when it is
in a flat position.
Á Close the sideload lever until the red safety lock is
locked (audible clicking).
Note: Adjustment of the clamping force
There are a lot of camera plates from other brands (e.g.
O`Connor, ARRI, ...) in the market. They principally fit to
the Cine 30 HD but may have other manufacturing toleran-
ces. If so, an adjustment of the clamping force is possible,
by turning the allen screw (see pic. 3) clockwise to increa-
se the force, counterclockwise to decrease clamping force.
- 6 -
Manual