Intended Use; Safety Information; Disposal Information - Bosch BSG6 Series Gebrauchsanweisung

en
Please keep this instruction manual.
When passing the vacuum cleaner on to a third party,
please also pass on this instruction manual.

Intended use

This vacuum cleaner is intended for domestic use and not
for commercial use.
Only use this vacuum cleaner in accordance with the
instructions in this instruction manual.
The manufacturer will not accept any responsibility for
damage caused by improper use or incorrect operation.
Therefore, please note the following points.
The vacuum cleaner must only be operated with:
the manufacturer's original dust bags.
manufacturer's replacement parts, accessories
and optional accessories
The vacuum cleaner is not to be used for:
vacuuming persons or animals
vacuuming up:
- insects (e.g. flies, spiders, etc.).
- hazardous, sharp-edged, hot or burning substances
- damp or liquid substances
- highly flammable or explosive substances and gases
- Ash, soot from tiled stoves and central heating
systems

Safety information

This vacuum cleaner complies with the recognised rules of
technology and the relevant safety regulations. We confirm
compliance with the following European directives:
89/336/EEC (amended by Directives 91/263/EEC,
92/31/EEC and 93/68/EEC). 73/23/EEC (amended by
Directive 93/68/EEC).
Always observe the information on the rating plate when
using the vacuum cleaner and connecting to the power
supply.
Never use the vacuum cleaner without a dust bag or dust
container fitted.
=> This can damage the vacuum cleaner.
Only allow children to use the vacuum cleaner under
strict supervision.
Keep the vacuum cleaner away from the face when using
tools and tubes.
=> Risk of injury.
Never carry the vacuum cleaner by the power cord.
Fully extend the power cord when using the vacuum
cleaner continuously for several hours.
When disconnecting the appliance from the mains, pull
the plug, not the power cord.
Do not pull the power cord around sharp corners or allow
it to become trapped.
Unplug the vacuum cleaner from the mains before
carrying out any work on it.
Do not use the vacuum cleaner if it is damaged. Unplug
the power cord from the mains if a fault is detected.
8
For safety reasons, only authorised after-sales service
personnel are permitted to carry out repairs and fit
replacement parts to the vacuum cleaner.
The vacuum cleaner should be protected from outside
weather conditions, moisture and sources of heat.
The vacuum cleaner is not suitable for use on building
sites.
=> Vacuuming up building rubble could damage the
vacuum cleaner.
Switch off the vacuum cleaner when it is not in use.
At the end of its life, the vacuum cleaner should be
disposed of in an appropriate manner.
For safety reasons, vacuum cleaners with a power rating
of more than 2000 W are fitted with a temperature safety
switch
which automatically switches the vacuum cleaner off if it
is blocked and overheating. Unplug the vacuum cleaner
from the mains and make sure that the nozzles, suction
pipe and hose are not blocked and check whether the
filter needs replacing.
Having cleared the blockage, leave the vacuum cleaner
to cool down for at least one hour.
It can then be switched back on again.

Disposal information

Packaging
The packaging is designed to protect the vacuum cleaner
from being damaged during transportation.
It is made of environment-friendly materials and can be
recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many recyclable
materials.
Therefore, please take used vacuum cleaners to your
retailer or recycling centre so that they can be recycled.
For current disposal methods, please enquire at your
appliance dealership or local council.
Please note
!
Only connect the appliance to a socket that is protected
by at least a 16 amp fuse.
If a fuse should blow when you switch on the vacuum
cleaner, this may be because other electrical appliances
which have a high current draw are connected to the
same power circuit.
To prevent the fuse from tripping, select the lowest
power setting before switching the vacuum cleaner on,
and increase the power only once it is running.