Subsonic-Filter - Clearaudio basic V2 Bedienungsanleitung

User manual / Bedienungsanleitung
Select cartridge type operation mode:
Set the switches on the bottom panel of the basic V2 chassis as follows:
• MM operation: Buttons 'gain' not pressed in (load impedance = 47 kOhm)
• MC operation: Buttons 'gain' pressed in (load impedance = 500 Ohm)
Position MM = button not pressed, Position MC = button pressed in.
MM Adjustment

Subsonic-Filter:

Set the switches on the bottom panel of the basic V2 chassis as follows:
• Subsonic filter is on: Both buttons 'subsonic' pressed in
• Subsonic filter is off: Both buttons 'subsonic' not pressed in
Subsonic off
All switches are duplicated for the left and right channels.
Please make sure that both corresponding switches are always in the same position.
Before switching any settings be sure to shut off the power to the basic V2.
Never cover or put anything on top of the
parts.
If the unit is not in use for an extended period, switch it off.
Made in Germany
- Setup -
MC Adjustment
Subsonic on
- Attention -
basic V2,
which could lead to overheating of electronic
3