Oase ProMax Garden 3500 Gebrauchsanleitung Seite 16

3. Pour water into the infill opening of the
pre-filter until it overflows. At the same
time, keep the non-return valve opener
open until the water has expelled any
remaining air from the filter.
4. Screw the filter cover back on.
5. Insert the power plug into the socket.
ProMax Garden 3500 / 5000
6. Switch on the pump. (→ Operation )
– The pump starts pumping immedi-
ately. The emerging water still con-
tains some air.
ProMax Garden 6000/5
– The pump restores the last operating
mode and indicates it with the LEDs
in the ON/OFF button. If the pump
was switched off, it is necessary to
switch it on now.
N O T E
If no water is taken in after 5 minutes, the
dry run protection switches off the pump.
(→ Operation)
ProMax Garden 3500 / 5000 / 6000/5
7. Close the shut-off device of the pres-
sure line as soon as there is no more air
in the emerging water. Air has now been
expelled from the suction line.
Shutting down the pump
N O T E
Rinse out the pump with clean water after
use.
How to proceed:
1. Switch off the pump
2. Disconnect the power plug.
3. Depressurise the pressure line by open-
ing the water withdrawal points.
4. Also open any non-return valves fitted in
the suction line.
16
– When the pump is switched off, resid-
ual water in the hose may flow back
and out of the pump intake.
If the pump is to be completely removed:
 D
5. Remove the connected hoses on the
pressure and suction side.
6. Undo the water drain screw and tip the
pump to allow the residual water to drain
out.
7. Screw in the water drain screw again.
OPERATION
• Press the rocker switch to switch the
pump on and off.
OPERATION
1 Blue LED
2 Red LED
3 ON/OFF button
• A sensor monitors the water flow and
switches the pump off after a certain
time when the pump cannot extract any
more water or the pressure line is
closed. The red LED is lit. (→ Operating
status and attendant LED displays)
• The lit or flashing LEDs in the ON/OFF
button indicate the respective operating
status.
Operating modes
Mode A (delivery state):
• Connect the pump to the power supply.
• Switching on: Press the ON/OFF but-
ton.
ProMax Garden 3500/5000/6000
POX0042