Beurer FM 150 Gebrauchsanweisung Seite 19

2. Place the leg cuffs one at a time secure-
ly over your lower legs and feet as shown;
have your legs bare or wear closely fitting
clothing (e.g. tights).
The leg cuffs should be fastened so that two
fingers fit under the cuff. If the leg cuffs feel
too tight, fasten the cuffs so that you can
get your flat hand under them.
3. For best results, your legs should be ele-
vated/slightly bent during the treatment to
aid circulation.
• The cuff for the left leg is marked with an
"L" on the inside.
• The cuff for the right leg is marked with an
"R" on the inside.
4. Connect the air hose to the leg cuffs. En-
sure the leg cuffs are securely in place and
cannot slip.
Connect the other end of the air hose to the
air inlet ("in") on the hand switch.
5. Press the ON/OFF button to switch on the
device. Once the device is switched on, the
20 minute timer LED lights up.
6. Please note that the timer begins to count
again when you change the timer setting.
IMPORTANT
We recommend an application time of 20 to 30
minutes. Using the massager for long periods
could result in a feeling of numbness in the legs
and could cause the device to overheat.
7. The intensity is adjusted using the air pres-
sure controller. Start at the lowest level so
that you get used to the massage gradually.
For best effects the intensity should be set
high, but at a level where it is still comfor-
table.
1.
stop
stop
19
L
R
2.
stop