Notes On Documentation; Safety Instructions; Product Description - Rittal DK 7030.130 Installationsanleitung Und Kurz-Bedienungsanleitung

EN
Notes on documentation, Safety instructions, Product description
1

Notes on documentation

This installation and short user's guide is intended for experienced trained specialists and contains only
EN
the most important information concerning the assembly, installation and function of the CMC III
Vandalism Sensor (subsequently called vandalism sensor).
1.1 Associated documents
CMC III Vandalism Sensor assembly, installation and user's guide.
It is available at www.rittal.com and contains the complete application-relevant information and techni-
cal data for the vandalism sensor with regard to:
– Further assembly possibilities
– Functions
– Configuration possibilities
– Detailed operating instructions
– Troubleshooting
2

Safety instructions

– Assembly and installation of the vandalism sensor may only be performed by experienced trained
specialists.
– The vandalism sensor housing must not be opened.
– The vandalism sensor may not come in contact with water, aggressive or inflammable gases and va-
pours.
– The vandalism sensor may only be operated within the specified environmental conditions (see
Section 3.4).
3

Product description

3.1 Functional description
The vandalism sensor registers vibrations in the X, Y and Z axes within the server enclosure. It signals
any changes to the connected CMC III PU. The vandalism sensor has an identification that allows it to
be detected automatically by the CMC III PU.
3.2 Proper use
The vandalism sensor is used only to monitor switch cabinets and server enclosures. It may be used
only together with the CMC III PU. Any other use is not permitted.
3.3 Scope of delivery
– CMC III Vandalism Sensor
– Provided accessories (see Fig. 1)
– Installation and Short User's Guide
3.4 Operating conditions
The vandalism sensor may only be operated under the following operating conditions:
Temperature operational range:
Humidity operational range:
Degree of protection:
5
+0°C to +55°C
5% to 95% relative humidity, non-condensing
IP30 in accordance with EN 60 529
Rittal CMC III Vandalism Sensor