Declaration Of Conformity; Battery Charging - Bosch GSC 10,8 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-840-004.book Page 15 Thursday, September 9, 2010 4:48 PM
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly in-
crease the exposure level over the total working
period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 01.06.2010
Bosch Power Tools
Assembly

Battery Charging

Use only the battery chargers listed on the
graphics page. Only these battery chargers
are matched to the lithium ion battery used
in your machine.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C.
A long battery service life is achieved in this
manner.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 4 indicate the charge condition of
the battery 2. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
To indicate the charge condition, press and hold
button 3 of the switched off machine.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Removing the Battery
To remove the battery 2, press the unlocking
buttons 1 and pull the battery out of the ma-
chine to the rear. Do not exert any force.
English | 15
Capacity
≥2/3
≥1/3
<1/3
Reserve
1 609 929 X59 | (9.9.10)