Storage; Service And Cleaning; Troubleshooting - Würth HDR 160 Compact Originalbetriebsanleitung

 When transporting in vehicles, secure the ap-
pliance according to the guidelines from slip-
ping and tipping over.

Storage

CAUTION
Risk of personal injury or damage! Con-
sider the weight of the appliance when
storing it.
This appliance must only be stored in interior
rooms.

Service and cleaning

DANGER
Risk of injury by inadvertent startup of
appliance and electrical shock.
Prior to all work on the appliance, switch
off the appliance and pull the power
plug.
ATTENTION
Keep the device and the ventilation lou-
vres clean in order to be able to work
well and safely.
Note:
Used oil must only be disposed of by the designat-
ed collection points. Please turn in used oil there.
Polluting the environment with used oil is prosecut-
able.
Before each use
 Check connection cable for damage (risk of
electric shock), have a damaged connection
cable replaced immediately by Würth Master
Service or a qualified electrician.
 Check the high pressure hose for damages
(risk of bursting).
Please arrange for the immediate exchange of
a damaged high-pressure hose.
 Check appliance (pump) for leaks.
3 drops of water per minute are permissible
and can leak out of the bottom of the appli-
ance. In case of more serious leaks, contact
Würth Master Service.
Weekly
 Check oil level. Contact Würth Master Service
immediately if the oil is milky (water in oil).
 Clean the sieve in the water connection.
 Clean filter at the detergent suck hose.
Every 500 operating hours, at least
annually
 Have the appliance maintained by Würth
Master Service.
 Oil change.
Oil change
Note:
See "Specifications" for oil volume and type.
 Unscrew the fastening screws of the device
hood; remove the device hood.
 Remove the lid of the oil container.
 Tilt the appliance forward.
 Drain the oil in a collection basin.
 Fill in new oil slowly; air bubbles should go out.
 Attach the lid of the oil container.
 Fasten the device hood.

Troubleshooting

DANGER
Risk of injury by inadvertent startup of
appliance and electrical shock.
– Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
– Have electrical components checked
and repaired by Würth Master Ser-
vice only.
– In case of any malfunctions not men-
tioned in this chapter, contact Würth
Masters Service when in doubt or
when you have been explicitly ad-
vised to do so.
Appliance is not running
 Check connection cable for damages.
 Check the supply voltage.
 Contact Würth Master Service in case of any
electrical defects.
GB - 6 19