Black+Decker BDCDC18 Bedienungsanleitung Seite 7

Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Forward/reverse slider
3. Torque adjustment collar
4. Keyless chuck
5. LED work light
6. Battery
7. Battery release button
Assembly
Use
Warning! Let the tool work at its own pace. Do
not overload.
Charging the battery (fi g. A)
The battery needs to be charged before fi rst use
and whenever it fails to produce suffi cient power
on jobs that were easily done before. The battery
may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Recommended charging temperature: approx.
24 °C.
Note: The charger will not charge a battery if
the cell temperature is below approximately
10 °C or above 40 °C.
The battery should be left in the charger and
the charger will begin to charge automatically
when the cell temperature warms up or cools
down.
♦ Plug the charger into any standard 230 Volts
50 Hz electrical outlet.
♦ Slide the battery pack into the charger as
shown in fi gure A.
♦ The green LED will fl ash indicating that the
battery is being charged.
♦ The completion of charge is indicated by the
green LED remaining on continuously. The
pack is fully charged and may be used at this
time or left on the charger.
Warning! fi re Hazard. When disconnecting the
charger from the tool, be sure to unplug the
charger from the outlet fi rst, then disconnect the
charger cord from the tool.
Installing and removing the battery pack
from the tool (fi g. B)
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery.
To install battery pack:
♦ Insert battery pack into tool, until an audible
click is heard (fi g. B)
Removing the battery pack from the tool
(fi g. C)
♦ Depress the battery release button as shown
in (fi g. C) and pull battery pack out of tool.
Operating Instructions
Torque control (fi g.D)
This tool is fi tted with a torque adjustment collar
(3) to select the operating mode and to set the
torque for tightening screws. Large screws and
hard workpiece materials require a higher torque
setting than small screws and soft workpiece
materials.
♦ For drilling in wood, metal and plastics, set the
collar to the drilling position symbol
♦ For screwdriving, set the collar to the desired
setting. If you do not yet know the appropriate
setting, proceed as follows:
♦ Set the collar to the lowest torque setting.
♦ Tighten the fi rst screw.
♦ If the clutch ratchets before the desired result
is achieved, increase the collar setting and
continue tightening the screw. Repeat until
you reach the correct setting. Use this setting
for the remaining screws.
Keyless chuck (fi g. E)
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
installing or removing accessories.
To insert a drill bit or other accessory:
♦ Grasp the rear half of the chuck (8) with one
hand and use your other hand to rotate the
front half (4) in the counterclockwise direction,
as viewed from the chuck end.
♦ Insert the bit or other accessory fully into the
chuck, and tighten securely by holding the
rear half of the chuck and rotating the front
portion in the clockwise direction as viewed
from the chuck end.
Warning! Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to
the chuck and personal injury may occur when
changing accessories.
Drilling/screwdriving
♦ Select forward or reverse rotation using the
forward/reverse slider (2).
ENGLISH
7