JVC TH-LB3-B Bedienungsanleitung Seite 17

Attaching the stand system
You can adjust the height of the unit by using the stand system
(supplied).
You can select two ways:
Attach the stands to the right and left side of the unit,
then stick the foot spacers under the stands.
Foot spacer
Attach the stand, stand bases, then stick the foot spacers.
•
The wider sides of the stands, stand bases, and foot spacers
should be facing the front to fit in the grooves on the bottom of
the unit.
•
The stands, stand bases, and foot spacers do not have the
difference between the left and right side.
Front of the unit
Stand
Screw for stand and stand
base (M2.6 × 10 mm)
Front of the unit
Stand base
Connecting the TV remote pass through
cable
If you install the unit near the TV, the unit may block the remote
control signal of the TV, and it may not be transmitted to the TV
unit. Connect the TV remote pass through cable (supplied) to the
unit for smooth signal transmission.
As illustrated below, connect the TV remote pass through cable to
the IR OUT terminal. Move the cable to the remote sensor of your TV
as closely as possible.
CAUTION
Even if you connect the TV remote pass through cable to the unit,
some TVs may not receive the remote control signal of the TV. Because
some TVs use different carrier frequency for the remote control.
Rear of the unit
TV remote pass
through cable
(supplied)
4
Move it to the
remote sensor of
your TV as closely
as possible, then
stick it in any rear
position of the unit.
Back
Double-sided
adhesive tape
(supplied)