Silvercrest IAN 113326 Wireless Doorbell Bedienungsanleitung Seite 14

CAUTION! Use the above-indicated battery types only. Failure to
observe this advice may result in damage to the product.
Receiver:
Remove the battery compartment cover
device.
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment
Transmitter:
Remove the holder
Open the battery compartment
cover anticlockwise.
Insert a battery (3 V
face upwards.
Place the battery compartment cover on the battery compartment
and tighten it by turning it clockwise.
Fasten the holder
12 GB/IE
, type AA).
.
10
from the back of the transmitter.
15
, type CR 2032). The side marked "+" must
of the receiver back on to the back of the device.
15
from the back of the
9
.
10
by turning the battery compartment
14
14