Installation; Installation Data - KKT KOLBE INTEGRA Benutzerhandbuch

Installation

7. Installation
!
On installation, the minimum distance
between the hob and the hood must be
exactly complied with (see chapter 7.1
"Installation data") and follow the num-
bering of the steps and the additional
instructions. Execution with air exhaus-
ted outdoors (A- see also the installation
data). The vapours are extracted via an air
exhaust hose fixed to the connector ring.
The diameter of the exhaust air hose
must conform to that of the connector
ring. If a smoke non-return valve is used
or is planned, check whether it can open
and close freely after the installation of
the exhaust air hose. The extractor hood
can be equipped with one (top) or two
(top and back) extractor openings.
The hood is normally initially fitted out
for use of the top extractor opening, as
an extractor hood.
250
320
30
Openings not required are fitted with a
plastic cover. This plastic cover can be
easily removed by turning counterclock-
wise and optionally fitted to another ope-
ning which is not required.

7.1 Installation data /

Minimum distance from the lower edge of
the hood body:
to ceramic and cast cooking hobs 65 cm.
to gas hob 70 cm.
to hobs with coal/oil/wood firing 85 cm.
280
dimensions
280
860
900
280
80