Beko DS 7433 PXW Bedienungsanleitung Seite 54

Operating the product
C
The laundry adding made after
the drying operation started may
cause the dried laundry inside
the machine to mix with the
wet laundry and the laundry to
remain damp after the operation
ends..
C
Laundry adding and removing
can be repeated as much as
desired during drying operation.
But this process would
continuously interrupt the
drying operation, and so would
cause the program duration
to lengthen and increase
energy consumption. Thus, it is
recommended to add laundry
before the program starts.
C
If a new program is selected by
changing the position of the
program selection knob while
your machine is in stand-by
mode, the running program ends.
Do not contact the inner surface
of the drum when adding or
removing laundry during a
continuing program. The drum
surface is hot.
5.14 Canceling the program
If you want to cancel the program and end
the drying operation for any reason after the
machine starts running, press the On/Off
button.
A
As it will be extremely hot inside
the machine when you cancel
the program while the machine is
in operation; run the ventilation
program to cool it down.
54 / EN
5.15 Program end
When the program ends, the Final/Wrinkle
Prevention, Fiber Filter Cleaning and Water
Tank Warning leds on the program follow
up indicator light up. Loading door can be
opened and machine becomes ready for a
second run.
Press the On/Off button to turn off the
machine.
C
In case the laundry is not
removed after the program
is completed, the wrinkle
prevention program that lasts 2
hours start in order to prevent
wrinkling of the laundry that
remains inside the machine.
C
Clean the fiber filter after each
drying. (See. „Fiber filter and
loading door inner surface")
C
Empty the water tank after
each drying. (See. „Emptying the
water tank")
Dryer / User Manual