Using The Remote Controller (Rm-Rk50) - JVC KD-R801 Bedienungsanleitung

e
Change the display information.
r
• Return to the previous menu.
• iPod FRONT/iPod REAR: Switch the
setting between <Headunit Mode> and
6
<iPod Mode> * [Hold].
• BT FRONT/BT REAR (Audio): Pause
playback [Press].
t • Control the volume *
• Confirm the selection [Press] .
• FM: Enter SSM preset mode [Hold] .
• CD/USB FRONT/USB REAR/iPod
FRONT/iPod REAR/: Pause/resume
playback * 2
[Press].
• BT FRONT/BT REAR (Audio): Resume
playback * 2
[Press].
• CD/USB FRONT/USB REAR/iPod
FRONT/iPod REAR/BT FRONT (Audio) *
BT REAR (Audio) *
mode [Hold].

Using the remote controller (RM-RK50)

Installing the lithium coin battery (CR2025)
Caution:
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
If the effectiveness of the remote controller
decreases, replace the battery.
2
or select items [Turn].
3
/CD-CH: Enter playback
y
Remote sensor
u
AUX (auxiliary) input jack
* 1
Also known as "Control dial" in this manual.
2
* You can still adjust the volume during pause when
the selected source is CD/USB FRONT/USB
REAR/iPod FRONT/iPod REAR/BT FRONT/
BT REAR/iPod.
Before resume playback, check to be sure that you
have not raise the volume level too much.
* 3
For Bluetooth devices that support AVRCP 1.3.
* 4
You cannot select these sources if they are not ready
or not connected.
5
* You cannot select these sources if they were disabled
in the <SET UP> menu (see <Source Select> in
"Menu operations" on page 31).
3 * 6
/ You can use this function only when <iPod Mode>
is available for the connected iPod (see pages 21 and
38).
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the unit.
• DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
Remote sensor
Continued on the next page
OPERATIONS 7