Confirmation Of Cip Testing; Noise Information - Hilti DX A40 Bedienungsanleitung

DXA40 with polyurethane marking head
Technical data:
Weight:
Tool length:
Marking characters:
Cartridges:
90% of all marking can be carried out using the green power load. The yellow power
load is one step higher. Please use the lowest possible power load in order to keep
wear of the piston, impact extractor and marking characters to a minimum.

Confirmation of CIP testing

The Hilti DX A40 has been system and type tested. As a result, the tool bears the PTB approval
mark of square shape showing approval number S 802. In this way, Hilti guarantees compliance
with the approved type.
Unacceptable/inadmissible defects, deficiencies, etc. that are determined during use of
the tool must be reported to the manager responsible at the approval authority (PTB)
and to the Office of the Permanent International Commission (C.I.P.).
Printed: 07.07.2013 | Doc-Nr: PUB / 5069861 / 000 / 00
4.05 kg
420 mm (16.5")
reference the data sheet 23484/C
6.8/11M green and yellow
X-A40/CM polyurethane marking head
Technical data:
Weight:
Marking characters:

Noise information

as per German legislation (3. GSGV dated January 18, 1991)
The noise (power) level L as per § 1 (2) 1b) applicable to the tool and, due to different work-
WA, 1S
places depending on the application for which the tool is used, also the noise (pressure) level L
at the measurement surface of 1 metre as per § 1 (2) 1e), are given in addition to the work-
Imax
place related noise emission value in accordance with the noise measurement standard. Operating
conditions and circumstances of use: most powerful cartridge power load in accordance with
instructions for use with suitable nail or stud fired vertically downwards into a steel plate and in
accordance with the means of measurement DIN 45635, part 34 «Measurement of the noise emit-
ted by powder-actuated fastening tools».
Noise information With black cartridge and maximum power setting
1b) Noise (power) level
workplace relevant emission value
(measured at operator ear level)
1e) Noise (pressure) level
Variations in operating conditions may cause deviations from these noise emission values.
1.3 kg
reference the data sheet 23484/C
L = 109 dB (A)
WA,1S
L = 103 dB (A)
pA, Imax
L' = 96 dB (A)
pA, Imax
pA,
11