Cable Routing Diagram - Yamaha TT-R125 Fahrer- Und Wartungs-Handbuch

EC240000

CABLE ROUTING DIAGRAM

TT-R125/TT-R125LW
1 Fuel tank breather hose
2 CDI unit
3 CDI unit band
4 Clamp
5 CDI magneto lead
6 Air vent hose
7 Wire harness
8 Engine stop switch lead
9 Cable guide
0 Brake cable
(Brake hose for the TT-R125LW)
A Brake cable holder
(Brake hose holder for the
TT-R125LW)
CABLE ROUTING DIAGRAM
Å Fit the CDI unit band over the CDI unit bracket till it stops.
ı Clamp the ignition coil lead.
Ç Clamp the wire harness coupler.
Î Clamp the CDI magneto lead, throttle cable and starter cable.
‰ Clamp the CDI magneto lead so that it does not contact the push
lever.
Ï Pass the air vent hoses between the engine and swingarm.
Ì Clamp the wire harness and engine stop switch lead.
Ó Pass the brake cable (brake hose for the TT-R125LW) into the cable
guide.
È Clamp the brake cable.
Ô Clamp the brake hose between the paint marks.
2 - 27
SPEC