Original Instructions "Cordless Hammer Drill; Symbols And Abbreviations; General Safety Instructions For Power Tools; Electrical Safety - Kress 360 BPS BiPower Originalbetriebsanleitung

39694_BA_360BPS.book Seite 15 Mittwoch, 18. April 2012 9:45 09

Original instructions "Cordless hammer drill"

Symbols and abbreviations

1. Symbols and abbreviations
The symbols used in these instructions and, if ap-
plicable, on the power tool, serve to bring your at-
tention to potential dangers when working with this
power tool. You must understand the significance
of these symbols/notes and comply with them in
order to make its use more efficient and safer.
The safety warnings, notes and symbols are not a
substitute for the prescribed accident prevention
measures.
Symbols
Especially important note on safety.
Always comply with these instruc-
tions. Failure to do so may result in
serious injury.
Warning of dangerous electrical volt-
age
Warning of hot surfaces
Illustrated or described accessories
are not necessarily included in the
scope of delivery
Technical modifications reserved
-WARNING-
For a potentially dangerous situation which could
lead to physical injury or material damage.
-NOTE-
Application instructions and other useful informa-
tion.
2. Safety instructions
General safety instructions for power
tools
Warning!
Read all safety instructions and other
instructions.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Keep all safety instructions and other
instructions for future reference.
The term "power tool" used in the safety instruc-
tions refers to mains operated power tools (with
mains cable/mains cable module) and to battery
operated power tools (without mains cable).
Safety in the workplace
Keep your work area clean and well lit.
Cluttered and dark areas lead to accidents.
Never operate your power tool in explosive atmos-
pheres, such as in the presence of flammable liq-
uids, gases or dust.
Power tools create sparks which may ignite dust
or fumes.
Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.

Electrical safety

Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use adapter
plugs with grounded power tools.
Unmodified plugs and matching outlets reduce the
risk of electric shock.
Avoid body contact with grounded surfaces such
as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your
body is grounded.
Protect the power tool against rain
and moisture.
The penetration of water into a power
tool increases the risk of electric
shock.
Do not misuse the cord. Never use the cord for
carrying or hanging up the power tool or to discon-
nect it from the mains. Keep cord away from heat,
oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of
electric shock.
When operating a power tool outdoors, use an ex-
tension cord suitable for outdoor use.
Use of an extension cord suitable for outdoor use
reduces the risk of electric shock.
If operating a power tool in a damp location is un-
avoidable, use a residual current device (RCD)
protected supply.
Use of an RCD reduces the risk of electric shock.
English 15
EN
360BPS-EN / 1205