Progress PAI8105E Benutzerinformation Seite 22

22 progress
Problem
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds
when the appliance is deactiva-
ted.
The appliance deactivates.
The residual heat indicator
does not come on.
The Automatic Heat Up func-
tion does not operate.
The heat setting changes be-
tween two levels.
The sensor fields become hot.
comes on
comes on
comes on
and number comes on.
Possible
You touched 2 or more sensor
fields at the same time.
The STOP+GO function oper-
ates.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the sen-
sor field .
The cooking zone is not hot
because it operated only for a
short time.
The cooking zone is hot.
The highest heat setting is set.
The Power management is ac-
tivated.
The cookware is too large or
you put it too near to the con-
trols.
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cooking
zone.
Incorrect cookware.
The diameter of the bottom of
the cookware is too small for
the cooking zone.
There is an error in the appli-
ance.
Remedy
Touch only one sensor field.
Refer to the chapter "Daily
Use".
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the cooking zone operated
sufficiently long to be hot,
speak to the service centre.
Let the cooking zone become
sufficiently cool.
The highest heat setting has
the same power as the Auto-
matic Heat Up function.
Refer to "Power management".
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and
activate it again.
Refer to the chapter "Daily
Use".
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller
cooking zone.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.