Replacing The Lamp; Technical Data - AEG SKS58800S0 Benutzerinformation

22 www.aeg.com

7.1 Replacing the lamp

7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

8. TECHNICAL DATA

Dimension of the recess
Voltage
Frequency
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover (refer to the
illustration).
4. Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
3.
Height
Width
Depth
If necessary, replace the defective
door gaskets. Contact the Service
Center.
880 mm
560 mm
550 mm
230 V
50 Hz