Periods Of Non-Operation; What To Do If - AEG SKS58800S0 Benutzerinformation

20 www.aeg.com
Take care of not to damage the
cooling system.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason it is recommended
that the outer casing of this appliance is
only cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment
to the mains supply.
6.2 Defrosting of the
refrigerator
Frost is automatically eliminated from
the evaporator of the refrigerator com-
partment every time the motor compres-

7. WHAT TO DO IF...

WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance does
not operate. The
lamp does not oper-
ate.
sor stops, during normal use. The de-
frost water drains out through a trough
into a special container at the back of
the appliance, over the motor compres-
sor, where it evaporates.
It is important to periodically clean the
defrost water drain hole in the middle of
the refrigerator compartment channel to
prevent the water overflowing and drip-
ping onto the food inside. Use the spe-
cial cleaner provided, which you will find
already inserted into the drain hole.

6.3 Periods of non-operation

When the appliance is not in use for
long periods, take the following precau-
tions:
• disconnect the appliance from elec-
• remove all food
• defrost (if foreseen) and clean the ap-
• leave the door/doors ajar to prevent
If the cabinet will be kept on, ask some-
body to check it once in a while to pre-
vent the food inside from spoiling in
case of a power failure.
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
tricity supply
pliance and all accessories
unpleasant smells.
There are some sounds during
normal use (compressor, refriger-
ant circulation).
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.