Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cable preparation and installation
For effective protection from electromagnetic noise, all signal cables
must be shielded, or located on conductive trays or in conduits.
Use 1-8 AWG Cu Wire rated for temperatures above 0 °C Only,
tighten to .5 lb-In. Strip wires to mm from the ends. Use a suitable
ferrule for multistranded wires (do not solder).
Input Signal Cabling
Use suitable twisted pair cable for the input signal connection.
Connections
Signal
Terminal
1
24 V DC (out)
2
Signal +
3
Not Used
4
Signal −
5
6
Not Used
7
8
9
Neutral (−)
10
Live (+)
11
Normally Closed
12
Common
13
Normally Open
14
Normally Closed
15
Common
16
Normally Open
Protective Earth
Note 1: Double lines indicate isolation between ports
- Caution risk of electric shock (screw terminals can carry high voltages)
Input signals
Power supply
Alarm channel one
(Relay Contacts)
Alarm channel two
(Relay Contacts)
Via stud on the underside of the case
1
Werbung
Kapitel
Inhaltsverzeichnis
