VEGA VEGABAR 63 Betriebsanleitung Seite 64

10 Anhang
sensor_range
l
"Sensor_range.unit' refers to 'Sensor_value', 'Max/Min_peak_sensor_value', 'Cal_point_hi/lo'
-
includes sensor unit: bar, PSI ...; only unit part of DS-68 is writable
-
simulate_primary_value
l
simulate_secondary_value_1
l
simulate_secondary_value_2
l
device status
l
"0: ""OK"" 13: ""non-specific error"" 17: ""Cal span too small"" 34: ""EEPROM memory fault"" 36:
-
""ROM memory fault"" 37: ""RAM memory fault"" 40: ""non-specific hardware fault"" 41: ""Sensor
element not found"" 42: ""No leaking pulse"" 43: ""No trigger signal"" 44: ""EMI error"" 113:
""Communication hardware fault"""
linearization type
l
Possible types of linearization are: linear, user defined, cylindrical lying container, spherical
-
container
"0: ""Linear"" 1: ""User def"" 20: ""Cylindrical lying container"" 21: ""Spherical container"""
-
curve_points_1_10
l
X and Y values for the user defined linearization curve
-
curve_points_11_20
l
X and Y values for the user defined linearization curve
-
curve_points_21_30
l
X and Y values for the user defined linearization curve
-
curve_points_31_33
l
X and Y values for the user defined linearization curve
-
curve status
l
Result of table plausibility check
-
"0: ""Uninitialized"" 1: ""Good"" 2: ""Not monotonous increasing"" 3: ""Not monotonous
-
decreasing"" 4: ""Not enough values transmitted"" 5: ""Too many values transmitted"" 6:
""Gradient of edge too high"" 7: ""Values not excepted"" 8: ""Table currently loaded"" 9: ""Sorting
and checking table"""
SUB_DEVICE_NUMBER
l
SENSOR_ELEMENT_TYPE
l
0: "non-specific"
-
display_source_selector
l
Selects the type of value that is displayed on the indication-/adjustement-module
-
"0: ""Physical value"" 1: ""Percent value"" 2: ""Lin percent value"" 6: ""Out(AI1)"" 7: ""Level"" 8:
-
""Out(AI2)"" 9: ""Out(AI3)"""
max_peak_sensor_value
l
Holds the maximum sensor value. Write access resets to current value. Unit derives from
-
'Sensor_range.unit'
Write access resets to current value
-
min_peak_sensor_value
l
Holds the minimum sensor value. Write access resets to current value. Unit derives from
-
'Sensor_range.unit'
Write access resets to current value
-
CAL_POINT_HI
l
64
VEGABAR 63 • Foundation Fieldbus