Continuous Flow - WimTec Smart Montageanleitung

EN
SMART
Function description

Continuous flow:

DIP switch 3
Enable the continuous flow function to fill the washbasin or a container.
'ON' position = Continuous flow function is enabled.
'OFF' position = Continuous flow function is disabled (default setting).
Activate continuous flow:
Deactivate continuous flow:
|
22 Washbasin fitting
1.
Approach the infrared sensor with your hand
(approx. 3 cm) and dwell - the water flow starts.
2. After the control LED flashes 3 times the continuous
flow will be activated for the set flush stop time.
Cleaning stop activated:
1.
Approach the infrared sensor with your hand
3 x
(approx. 3 cm) and dwell - the water flow starts.
2. After the control LED flashes 5 times the water flow
stops and the cleaning stop is activated for 3 min.
3. After further 3 times flashing the water flow starts again and
the continuous flow is enabled for the set flush stop time.
Automatic:
After the flush stop time has elapsed
(see time control, page 18).
Manual:
1.
To instantly end the continuous flow, approach the infrared
sensor with your hand (approx. 3 cm) again and dwell.
3x
2. After the control LED flashes 3 times the continuous flow
is disabled and the fitting will resume normal operation.
WimTec SMART
ON
OFF
1 2 3 4 5 6