Cleaning Stop - WimTec Smart Montageanleitung

SMART
Function description

Cleaning stop:

DIP switch 2
Serves to disable the fi tting prior to cleaning.
'ON' position = Cleaning stop function enabled.
'OFF' position = Cleaning stop function disabled (default setting).
Activate cleaning stop:
Deactivate cleaning stop:
3 min |
1. Approach the infrared sensor with your hand
(approx. 3 cm) and dwell - the water fl ow starts.
2.
After the control LED fl ashes 5 times the water fl ow
stops and the cleaning stop is activated for 3 min.
During the cleaning stop the controll LED will
fl ash 2 times every 3 s.
5x
Automatic:
The fi tting will resume normall operation after 3 min.
Manual:
1. To instantly end the cleaning stop, approach the infrared
sensor with your hand (approx. 3 cm) again and dwell.
2. After the control LED fl ashes 3 times the cleaning stopp
3x
is disabled and the fi tting will resume normal operation.
WimTec SMART
Washbasin fi tting
EN
ON
OFF
1 2 3 4 5 6
21