Charger; Charging The Battery - Zipper Maschinen ZI-GPS40V-AKKU Betriebsanleitung

13.3

Charger

Charging the battery:

1. Connect the charger to the power supply (AC outlet) 230 V / 50 Hz
2. Insert the battery into the slots of the charger and slide into place until the battery locks into
place.
3. Charge the battery
4. Once the battery is fully charged remove the battery and slide out the battery of the charger
5. Li-Ion batteries have nor memory effect. A partial charge will not damage the battery.
LED- indicator light charger:
LED lights RED: Charger is ready to charge but no battery is connected.
LED flashes RED: Charging status 0 - 30%
LED flashes YELLOW: Charging status 30 - 90%
LED flashes GEEN: Charging status 90 – 99 %
LED lights GREEN: Charging status 100%
LED flashes fast YELLOW: Battery is fault or overheated
LED- indicator light battery:
Battery condition (2) can be checked at any time by
pressing the status button (1).
>75%
25 – 75 %
<25%
Charge the battery
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-GPS40V-AKKU
OPERATION
44