Operation; Stand-Alone Mode; Control Board - Futurelight PRO Slim PAR-36 CW Bedienungsanleitung

OPERATION

After you connected the spot to the mains, the FUTURELIGHT PRO Slim PAR-36 CW/WW starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
Attention: After every 8 FUTURELIGHT PRO Slim PAR-36 CW/WW, the fixtures must have a renewed
connection with the power mains.
The device has two operating modes. It can be operated in stand-alone or in DMX-controlled mode.

- STAND-ALONE MODE

Internal programs (master mode) / speed
Setting LED colors / color temperature, 0 – 100% (master mode) / strobe effect
Setting preset color temperatures
Setting dimmer speed (step response)
- DMX MODE
Setting DMX Channel Mode
Stand-alone mode
In the stand-alone mode, the FUTURELIGHT PRO Slim PAR-36 CW/WW can be used without controller.
Disconnect the FUTURELIGHT PRO Slim PAR-36 CW/WW from the controller.

Control Board

The Control Board offers several features: you can simply set the starting address or run the internal
programs.
Browse through the main menu by pressing MODE. Press ENTER in order to select the desired menu. You
can change the selection by pressing UP or DOWN. Confirm every selection by pressing the ENTER button.
The functions provided are described in the following sections. You can leave every mode by pressing the
MODE button.
Setting internal programs / speed
When the display shows P, you can select the desired internal program. Please see the following table.
Mode:
P
Press the MODE button until the display shows S___. Press the ENTER button and select the desired speed
(S001 – S100, increasing speed) via the UP or DOWN buttons. Press ENTER to confirm.
Setting LED colors / color temperature (0 – 100%) / strobe effect
When the display shows U, you can select the dimmer itensity of the LED colors from 0 to 100 % (0-255) and
the desired strobe speed from 1 to 20 (increasing speed).
Please see the following table.
Mode: Value:
A 0 - 255
W
0 - 255
S 1 - 20
Setting dimmer speed (step response)
Press the MODE button until the display shows DIM. Press the ENTER button. You can select OFF / DIM1 /
DIM2 oder DIM3 (decreasing speed) via the UP or DOWN buttons. Confirm your choice by pressing ENTER.
Value:
P--1
P--2
P--3
P--4
P--5
Function:
Warm white (0-100%)
Cold white (0-100%)
Strobe effect with increasing speed
Function:
Internal program 1
Internal program 2
Internal program 3
Internal program 4
Internal program 5
24/28 00064840.DOC, Version 1.1