Cleaning And Maintenance - BOMANN DU 652 IX Bedienungsanleitung

II II II II Power level: Power level:
Power level: Power level:
The motor runs at moderate speed. This setting is suitable for normal cooking. The motor runs at moderate speed. This setting is suitable for normal cooking.
III III III III Power level: Power level: Power level: Power level:
The motor runs at high speed. The setting is suitable if large quantities of smoke and steam need to be The motor runs at high speed. The setting is
tracted or filtered (e.g. when frying).
NOTE: : : : NOTE
NOTE NOTE
If a lot of vapour is produced, the fan should be left running for a few minutes after cooking. Only leave the fan f a lot of vapour is produced, the fan should be left running for a few minutes after cooking. Only leave the fan f a lot of vapour is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
running if absolutely necessary, since otherwise unnecessary energy is consumed. running if absolutely necessary, since otherwise unnecessary energy is consumed.
The appliance and the operation there
well as the filter. The extractor hood and
WARNING: WARNING:
WARNING: WARNING:
• Before cleaning or maintenance work, the device should always turn off and Before cleaning or maintenance work, the device should always turn off and disconnect
switch off the fuse.
• Allow the unit to cool down before
• Do not uses steam cleaners for
electric shock! Hot steam could dam electric shock! Hot steam could damage the plastic parts. The device must be dry before restarting.
electric shock! electric shock!
CAUTION CAUTION CAUTION: : : : CAUTION
• Do not use a wire brush or other sharp, abrasive items. Do not use a wire brush or other sharp, abrasive items.
• Do not use any acidic or abrasive Do not use any acidic or abrasive cleaners.
• To clean the surface of the housing, use a mild
• The appliance can be used again after The appliance can be used again after everything has dried properly.
• If you use your extractor hood in recirculation mode, you must
(see "Replacing the activated carbon
Cleaning the aluminum grease filter Cleaning the alumin um grease filter
Cleaning the alumin Cleaning the alumin um grease filter um grease filter
WARNING: Risk of fire! WARNING: Risk of fire! WARNING: Risk of fire! WARNING: Risk of fire!
Grease residues in the alumin Grease residues in the aluminum grease filter may ignite on exposure to high te
peratures. It is therefore important that the peratures. It is therefore important that the grease filter is regularly cleaned / r
placed.
Grease and vapours collect in the filter
clean the grease filter monthly:
• Remove the aluminum grease filter
tly and pull out towards the front.
• Rinse the grease filter in a solution
• Then clean with a soft brush, rinse
Cleaning

Cleaning and Maintenance

Cleaning Cleaning
thereof are best maintained by regular cleaning of your
tractor hood and accessories should also be cleaned regularly for hygiene reasons. accessories should also be cleaned regularly for hygiene reasons.
fore cleaning.
cleaning the device; moisture could enter electrical
housing, use a mild detergent and a soft cloth to prevent scratching.
tractor hood in recirculation mode, you must replace the activated
bon filter").
um grease filter may ignite on exposure to high tem-
filter and may accumulate if not regularly cleaned. We
filter by sliding back the lock in the handle recess,
solution of hot water and neutral detergent. Soak the filter
rinse thoroughly with hot water and leave to dry.
and Maintenance
and Maintenance and Maintenance
e must be dry before restarting.
grease filter is regularly cleaned / re-
23
ke and steam need to be ex-
ing of your extractor hood as
connect the mains plug or
electrical components. Risk of
vent scratching.
vated carbon filter regularly
cleaned. We recommend that you
cess, push the filter down gen-
filter in the solution.
Risk of Risk of Risk of