ZyXEL Communications VMG5304 Anleitung Seite 27

Connecting devices to the wireless network
L L
NOTE
The Wi-Fi feature of the VMG5304 must be enabled. Check the WLAN LED on
the front panel of your device to ensure that this is the case. It should be lit solid
green. If not, press the WLAN
button of the VMG5304 briefly (for about 1 second). The WLAN LED starts flashing
green and lights solid after approx. 15 seconds.
In a wireless home network, the connection between devices is established via
radio signals. This requires the devices to be equipped with a wireless adapter
that supports the 802.11 b/g/n standards.
The procedure for connecting wireless devices with your VMG5304 varies,
depending on the operating system (Windows, Linux, MacOS, Android, etc.).
Please consult the manual of your device for specific details.
Connecting devices under Windows 10
Click in the Start menu on Settings.
„
Click on the entry Network and Internet.
„
Click on WLAN and you verify that the Wireless network connection is set to
„
On.
Click under Wireless Network Connection on the wireless network name
„
(SSID) of your VMG5304 and then click Connect.
You will find the name of the wireless network (SSID) and the wireless security
key for the factory default settings on the nameplate at the rear of the device.
Enter the wireless security key (WPA2 key) in the Enter Network Key input field
„
and click Next.
Connecting devices under Android
For smartphones and tablets with the operating system Android 4.xx or higher,
please follow these steps:
Tap on the Settings icon and then select the item Wi-Fi.
„
Activate the Wi-Fi function.
„
Tap on the Wi-Fi name (SSID) of your VMG5304.
„
You will find the name of the wireless network (SSID) and the wireless security
key for the factory default settings on the nameplate at the rear of the device.
Enter the Wi-Fi key (WPA2 key) of your VMG5304 in the Password input field and
tap Connect.
EN
©2017 | 27