Tools; Removal Of Door Paneling - Eton UG VW-PASSAT 3c-R Anleitung

Tools

The following tools are required and should be available:
• Screw driver for Torx – size TX 20
or screw driver or small ratchet wrench with a bit head and bit size TX 20
Screw driver for Torx – size TX 30
or screw driver or small ratchet wrench with a bit head and bit size TX 30
Screw driver for cross screws – size PH 2
or screw driver or small ratchet wrench with a bit head and bit size PH 2
Screw driver for cross screws – size PH 3
or screw driver or small ratchet wrench with a bit head and bit size PH 3
Screw driver slot screws – size about 5 mm
Accumulator screw machine or drill machine
5 mm bit
Side cutter
Electrical pliers
9
Removal of rear side paneling
Step 1

Removal of door paneling

Tip: Before beginning Shut-off ignition and all electrical devices.
For mechanical window regulator:
Open door lock according to arrow and remove window crank .
Tip: If standard loudspeakers are already installed be careful of the plug
connections of the already existing tweeters when you remove the door
paneling. Loosen the plug connections.
Loosen the door opening cable. For this purpose press the 2 flaps of the clamp together
and remove the clamp. Unhook the knob of the door opening cable.
remaining clips out of the door and re-insert them in the paneling.
Illu. 1
Carefully pry off the lower grip cover and
remove the 2 screws (Torx 30) (arrows)
underneath.
The door paneling is fastened with clips
(circles). Carefully pry off the paneling,
beginning at the lower inner corner working
your way upward. Then pry the paneling
carefully out of the window slot.
Illu. 2
Pry possibly
10