Master/Slave-Operation; Control Board - EuroLite LED TSL-150 Bedienungsanleitung

Disconnect the LED TSL-150 Scan COB from the controller. Please refer to the instructions under Control
Board.

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED TSL-150 Scan COB you can find an XLR-jack (DMX Out) and an XLR-plug
(DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set „Mast" - for the master-device, as described in chapter Control Board. Set "Slv1" or "Slve2" for all slave-
devices.

Control Board

The Control Board offers several features: you can e. g. simply set the starting address.
The main menu is accessed by pressing the Mode button. Browse through the menu by pressing Up or
Down. Press the Enter button in order to select the desired menu. You can change the selection by pressing
Up or Down. Confirm every selection by pressing the Enter button. You can leave every mode by pressing
the Mode button. The functions provided are described in the following sections.
Main menu
DMX Set
Address
Mode Set
Slve1/Slve2
Show Mode Show 1/2/3/0
Sound Mode
Sound Sense
No DMX Set Blac/Auto/Sound/Hold
Back Led Light
Pan Inverse
Tilt Inverse
Fixture Reset
Sub menu Function
001-512 DMX address setting
Master/Slave setting
Mast: Master-Mode setting
Mast/
Slve1: Slave-Mode 1
Slve2: Slave-Mode 2
With this function, you can define the device as slave.
Internal programs 0 – 3 (Auto)
ON/OFF Sound controlled mode
0-100 Microphone sensitivity (increasing)
Status if no DMX-signal
Blackout/Auto/Sound/Hold
Display turn off
OFF/ON ON - Display always on
OFF - Shuts off the display after a few seconds
OFF/ON
Reverse PAN/TILT movement
OFF/ON
Yes/No Reset
22/26 00101272, Version 1.0