Danger To Life; Dmx-512 Connection / Connection Between Fixtures - EuroLite LED TSL-150 Bedienungsanleitung

dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

DMX-512 connection / connection between fixtures

Projector 3 Projector 3
Starting address 19 Starting address 19
SAFETY ROPE
POWER SUPPLY:
100-240V~ 50/60Hz
FUSE: T1A, 250V
LIGHTING CONTROL
PROTOCOL DMX512
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
DMX IN DMX OUT
120 Ohms 120 Ohms
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.

DANGER TO LIFE!

Projector 2 Projector 2
Starting address 10 Starting address 10
SAFETY ROPE
LIGHTING CONTROL
PROTOCOL DMX512
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
DMX IN
the fixtures will not work at all, or will not work properly.
POWER SUPPLY:
100-240V~ 50/60Hz
FUSE: T1A, 250V
DMX OUT
20/26
Projector 1 Projector 1
Starting address 1 Starting address 1
SAFETY ROPE
POWER SUPPLY:
100-240V~ 50/60Hz
FUSE: T1A, 250V
LIGHTING CONTROL
PROTOCOL DMX512
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
DMX IN DMX OUT
DMX-512 Controller DMX-512 Controller
00101272, Version 1.0