Troubleshooting; Technical Data - BOMANN WTK 5020 Bedienungsanleitung

Before you contact an authorized specialist.
The following problems can be solved by you by checking for the possible cause.
Problem
The appliance does not function/start.
The housing is hot or there is a smell of
burning.
Unusual odours and powerful vibrations.
Fabrics are too dry.
Fabrics are misshapen.
Error messages
Display indicator
Lint filter is blocked
Condenser water tank is full
E30 Problem with heating element or thermostat
E32 Problem with moisture sensor
E33
Problem with temperature sensor
E34
NOTE:
If a problem still persists after following the steps above, contact your distributor or an authorized technician.

Technical Data

for household tumble dryers in compliance with:
Delegated Regulation (EU) No. 392/2012
Model
Rated capacity
Dryer type
Energy efficiency class1 1)
Energy consumption
Annual energy consumption 2)
Automatic tumble dryer
Energy consumption standard programme
- with full load
- with partial load
Power consumption in off-mode
Power consumption in left-on mode
Duration of the left-on mode
3)
Standard programme

Troubleshooting

Cause/action
- Check the power supply.
- Is the appliance switched on or a programme selected?
- Have you pressed the START/PAUSE button?
- Check the maximum capacity guidelines.
- The lint filter is blocked and must be cleaned.
- The condenser must be cleaned.
- The appliance must stand on a solid base.
- Are the screw-in feet aligned?
- Check the maximum capacity guidelines.
- Was the washing removed in time?
- The washing was not properly sorted.
- Set the correct temperature.
Always follow the instructions on the care label of your fabrics.
Cause of problem Action
Clean or unblock the lint filter and if necessary, the vents
and restart the appliance.
Empty the condenser water tank.
Call a specialist.
WTK 5020
Condenser
kWh/year
kWh
kWh
W
W
Min.
Standard cotton
8 kg
B
561
yes
4,74
2,56
0,28
1,72
10
21