Control Panel; Installation; Startup / Operation - BOMANN WTK 5020 Bedienungsanleitung

1 Control panel 4

Filter unit
2 Appliance door 5 Maintenance flap 8 Mains plug
3 Air intake 6 Condenser

Installation

WARNING:
• Pipes and electrical fittings may only be fitted by qualified
specialists.
• During installation, the appliance must not be connected
to the mains power. Otherwise danger to life, as well as
risk of electric shock exists!
NOTE:
The appliance cover cannot be removed.
Requirements for the installation location
• Good ventilation is required around the appliance. Suffi-
cient clearance must be created for this purpose:
- Gap to the side walls and the back wall is 10 cm;
- Clearance in front of the appliance must be created
so that the appliance door can open without being
impeded.
• The ambient temperature should be between 5 and 35°C.
• Install the appliance in a clean location.
• Always set the appliance onto a stable and secure surface
in order to reduce vibration and noise to a minimum.
• If the appliance does not stand level, adjust the screw-in
feet accordingly (see "Adjusting the screw-in feet").
• The appliance must be set up in such a way that the mains
socket is easily accessible.
Avoid installing:
•
- On surfaces which are not heat resistant.
- Next to heating appliances, a cooker, direct sunlight, or
other sources of heat.
16
-
-
- Next to volatile and inflammable materials (e.g. gas,
Adjusting the screw-in feet
Make sure that the appliance stands securely and level. Adjust
for an uneven floor by turning the screw-in feet.
The feet must have secure contact with the floor. Use a spirit
level to check whether the appliance is level. If the appliance is
7 Lint filter
not balanced, the screw-in feet must be adjusted again.
CAUTION:
Condenser
The feet may not be removed. Do not block the gap between
9
water tank
floor and appliance with carpets, wood blocks, or similar.
This may cause a build-up of heat, which in turn impairs the
operation of the appliance.
Electrical connection
WARNING:
• The installation to the mains supply must conform to the
local standards and regulations.
• Improper connection may cause to an electric shock!
• In no event the device should be connected to an exten-
sion cord, adapter plug or the like.
• Do not modify the plug provided with the appliance. If the
plug does not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must always be
ensured in order to disconnect the device from the power
supply in case of an emergency.
• Ensure that your mains power corresponds with the specifi-
cations of the appliance. The specifications are printed on
the rating label.
• Connect the mains cable to a properly installed and earthed
wall outlet.
• Use the required 12 amp fuse, a time delay fuse or circuit
breaker recommended and provide a separate power
protection for this device.
Before initial use
• Ensure that the electrical connections correspond to the
installation instructions.
• Remove all accessories and other materials from the drum.
• Clean the drum. Follow the instructions which we provide in
the chapter, "Cleaning".
• First run through a drying cycle for approx. 30 minutes with
old, damp cloth (see "Starting the dryer").
In locations of high humidity (e.g. outdoors), since the
metal parts are susceptible to rust in these cases.
In locations in which the temperature could fall below
the freezing point. Never expose the appliance to the
elements.
petrol, alcohol, paint, etc.).

Startup / Operation