Start The Drying Cycle - BOMANN WTK 5020 Bedienungsanleitung

3 Additional options
Note that that the selection of the functions depends on
which program has been selected. The functions are set af-
ter the program selection and before pressing the START/
PAUSE button. The related control lamp indicates that the
function has been activated.
Gentle drying
This function works at a reduced drying temperature for
heat-sensitive washing. This extends the duration of the
drying cycle.
Anti-crease
This function is designed to prevent creasing. After the
end of the programme, the appliance adds an automatic
anti-crease phase of approx. 30 minutes, if the fabrics are
not removed immediately after the end of the programme. If
the anti-crease function is activated, the dryer will continue
to turn the drum at intervals for approx. two hours.
4 Activation/ Deactivation of the child lock
A child lock is available in order to prevent interruption of
the operation of the appliance through misuse by playing
children. After starting the programme, hold down the
Gentle Drying and Anti-Crease buttons for a few seconds.
A beep will sound. All buttons, apart from the On/Off button,
are locked. If the child lock is activated, any invalid button
press is indicated by a beep. Hold down both buttons
again at the same time to deactivate the child lock. A beep
sounds again.
5 Time selection TIME
If the WARM program has been selected you can set the
drying time yourself. By repeatedly pressing the button, you
can set the desired time shown on the display to between
20 and 60 minutes.
Drying programme table
NOTE:
• The figures listed below are approximate figures and recommendations under normal operating conditions and are therefore
for information only.
• The programme running times may deviate from the specified figures according to load, remaining moisture, and temperature.
Programme Drying setting
Baumwolle
Leicht (Light)
(Cotton)
Bügelfeucht (iron dry)
Standard
Extra
Pflegeleicht
Leicht (Light)
(Easy Care)
Normal
Extra
Feinwäsche
-----
(Delicates)
18
6 Delay start 1-24H
Select delay start, if you want to postpone the drying
process until later. By repeatedly pressing the button, you
can set the desired delayed start shown on the display to
between 1 and 24 hours. In order to deactivate the delay
start, you must switch the dryer off and on.
7 Status indicators
While the program is running, the control lamps indicate
which drying stage has just been reached.
8 START/PAUSE
Press the button to start or pause operation. If the
programme is running, the programme control lamp of the
selected programme will flash. If no programme is started
within approx. 10 minutes, the appliance switches off
automatically.
9 Display indicators
- The ZEIT and the selected delay start 1-24H.
- After the start of the drying program, the remaining
drying time [REMAIN] is shown as [x:xx] hours and
minutes.
- The delay start [DELAY] is displayed if it has been set.
The program is started after [xx] hours.
- Explanation of symbols:
The child lock is activated.
The condenser water tank must be emptied.
The lint filter must be cleaned.
- Error codes are displayed in the event of a fault.

Start the Drying cycle

Load in kg Remaining
(dry weight) moisture
8 kg 60 %
3,5 kg 40 %
3 kg -----
Energy
Time Min.
consumption kWh
65 3,1
90 3,9
130 4,8
150 5,2
42 1,3
57 1,6
60 2,0
60 2,0