Appliance Description - Beurer ELLE HLE 60 Gebrauchsanweisung

WARNING: Fire hazard
There is a risk of fire if the device is used incorrectly or if it is not used according to these operating
instructions.
For this reason, the massage device must only be operated as follows:
• Never leave the device unsupervised, particularly if children are around.
• Never use the device under covers, such as blankets or pillows.
• Never use the device in the vicinity of petrol or other easily flammable materials.
CAUTION: Disposal
Follow local regulations regarding the disposal of materials. The appliance should be dispo-
sed of according to Regulation 2002/96/EC-WEEE (Waste Electrical and Electronic Equip-
ment). In case of queries, contact the municipal authorities responsible for waste disposal in
your area.
Remove the battery before disposing of the device at an official recycling point. Before removing the
battery, disconnect the device from the charger and wait until the motor comes to a complete stop.
Remove the front cover using a screwdriver and loosen the screws underneath. Finally, disconnect
the battery. Dispose of the used battery at a collection point.

3. Appliance description

1. Base device
2. Base station
3. Epilator attachment
4. Precision attachment
5. Exfoliation attachment
6. Shaver attachment
7. Unlock button
8. Fixing cap
9. "Epilight"
10. Battery level indicator
11. On/off switch with 2 speed settings
12. Protective cap
4. Operation
• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power. The device must be switched off at this time.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Charge the device for 2 hours before the first use.
• If the charger indicator lamps flash slowly this means that the battery is charging. Once the display is
permanently illuminated, the device is fully charged.
• Then you can begin using the device either on battery power or using the mains cable.
• If the charger indicator lamps flash rapidly during battery operation, the battery is empty.
Charge the device by placing it on the station or connecting it to the mains adapter.
3
11
7
10
8
8
1
10
8
2
5
9
6
12
4
3