Speed Control; Technical Information - ECG RM 993 Bedienungsanleitung

1. Insert the spatula into the spatula holder and insert this holder into the appliance body, until it clicks.
2. Insert the spatula into the bowl before pressing the button to switch the appliance on.
3. After you are fi nished, unplug the appliance from the outlet and press the button for replacing the
attachments to disconnect the spatula holder. Then remove the spatula from the holder.

SPEED CONTROL

We recommend the following setup for individual attachments:
• Mixer – low speed button + speed control set to 1-5 or TURBO button
• Chopper – TURBO button
• Beater – low speed button + speed control set to 2-4 or TURBO button
CLEANING
Disconnect the appliance from the electrical output prior to performing any maintenance. Cleaning shall
always be performed on a cooled appliance! Do not use steel wool, abrasive agents or solvents.
1. Wipe the top of the blending attachment, chopping bowl lid and spatula holder with a damp towel. Do
not place into water because the lubricant could be washed away from the bearings.
2. Wipe the appliance body with a damp cloth. Never clean it under running water, do not rinse or immerse
the iron into water! Attach the attachment back on to the appliance body.
3. Wash the mixing bowl, chopping bowl, bottom part of the blending attachment, spatula and blade in
warm soap water. We do not recommend washing the dishes in a dishwasher.
Always make sure the immersion blender is completely cooled, clean and dry before putting it away.
Quick rinsing
Between individual blending tasks, hold the immersion blender in a glass, half fi lled with water and leave the
blender running for a few seconds.
Attention
The plastic parts of the appliance may become coloured after processing colourful foods.

TECHNICAL INFORMATION

Noise level: 80 dB
Nominal voltage: 230 V ~ 50 Hz
Nominal input power: 600 W
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into
plastic recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specifi ed location for recycling electric and electronic equipment. Prevent
negative impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the
product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg.cz.
Changes in text and technical parameters reserved.
GB
08/05
27