On/Off Switch - Black & Decker KA85 Anweisungen

ENGLISH
g. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power tool
for operations different from those intended could result
in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Additional safety instructions for sanders
Warning! Contact with or inhalation of dusts arising
x
from sanding applications may endanger the health of the
operator and possible bystanders. Wear a dust mask
specifically designed for protection against dust and
fumes and ensure that persons within or entering the
work area are also protected.
Thoroughly remove all dust after sanding.
x
Take special care when sanding paint which is possibly
x
lead based or when sanding some woods and metal
which may produce toxic dust:
- Do not let children or pregnant women enter the work
area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris safely.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Features

1. On/off switch

2. Lock-on button
3. Variable speed control knob (KA85E)
4. Tension lever
5. Dust extraction outlet
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting a sanding belt (fig. A)
Warning! Never use the tool without a sanding belt.
Pull the tension lever (4) outward to release the tension
x
on the sanding belt (6).
Remove the old sanding belt.
x
4
Place a new sanding belt over the rollers. Ensure that the
x
arrow on the sanding belt points in the same direction as
the arrow on the tool.
To ensure a correct tracking, the sanding belt must be
x
centred over the rollers.
Push the tension lever (4) inward to tension the sanding
x
belt.
Fitting and removing the dustbag (fig. B)
Slide the dustbag (7) over the dust extraction outlet (5).
x
To remove the dustbag, slide it off the outlet.
x
Use
Warning! Let the tool work at its own pace. Do not overload.
KA85E - Variable speed control (fig. C)
The variable speed control allows you to adapt the speed of
the tool to the workpiece material.
Set the control knob (3) to the desired setting. Use a high
x
speed for wood, medium speed for veneer and synthetics
and low speed for acrylic glass, non-ferrous metals and
for removing paints.
Switching on and off
To switch the tool on, press the on/off switch (1).
x
For continuous operation, press the lock-on button (2) and
x
release the on/off switch.
To switch the tool off, release the on/off switch.
x
To switch the tool off when in continuous operation,
press the on/off switch once more and release it.
Emptying the dustbag
The dustbag should be emptied every 10 minutes.
Unzip the bag and empty it before continuing.
x
Hints for optimum use
Always hold the tool with both hands.
x
Do not exert too much pressure on the tool.
x
Regularly check the condition of the sanding belt.
x
Replace when necessary.
Always sand with the grain of the wood.
x
When sanding new layers of paint before applying
x
another layer, use extra fine grit.
On very uneven surfaces, or when removing layers of
x
paint, start with a coarse grit. On other surfaces, start
with a medium grit. In both cases, gradually change to a
fine grit for a smooth finish.
Consult your retailer for more information on available
x
accessories.