Functional Description; Intended Use; Product Features - Bosch gof 1300 ce Professional Originalbetriebsanleitung

Do not use blunt or damaged router bits.
Blunt or damaged router bits cause in-
creased friction, can become jammed and
lead to imbalance.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for routing grooves,
edges, profiles and elongated holes as well as
for copy routing in wood, plastic and light build-
ing materials, while resting firmly on the work-
piece.
With reduced speed and with appropriate rout-
ing bits, non-ferrous alloys can also be ma-
chined.
Bosch Power Tools

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Right handle
2 Lock-on button for On/Off switch
3 Thumbwheel for speed preselection
4 Spindle lock lever
5 Wing bolt for guide rods of parallel guide
(2x)*
6 Chip shield
7 Router bit*
8 Seat for parallel guide rods
9 Guide plate
10 Step buffer
11 Adjusting screws for step buffer
12 Base plate
13 Dust boot
14 Wing bolt for depth stop adjustment
15 Depth stop
16 Slide with index mark
17 Left handle
18 Scale for depth-of-cut
19 Scale for depth-of-cut fine adjustment
20 Adjustment knob for depth-of-cut fine ad-
justment
21 Mark for zeroing
22 Release lever
23 Tightening nut with collet
24 On/Off switch
25 Open-end spanner, size 24 mm*
26 Extraction hose (Ø 35 mm)*
27 Extraction adapter*
28 Knurled screw for extraction adapter (2x)*
29 Parallel guide*
30 Guide rod for parallel guide (2x)*
31 Wing bolt for fine adjustment of parallel
guide (2x)*
32 Wing bolt for coarse adjustment of
parallel guide (2x)*
33 Fine-adjustment knob for parallel guide*
34 Edge guide for parallel guide*
English | 21
1 609 929 N93 | (2.9.08)