Maintenance And Cleaning; Lint Filter / Loading Door Inner Surface; Cleaning The Sensors - Grundig GTN 38250 G Bedienungsanleitung

Maintenance and cleaning

7
Service life of the product extends and
frequently faced problems decrease if cleaned
at regular intervals.
CAUTION: Unplug the product from
B
the mains during any maintenance and
cleaning works (control panel, body,
etc.).
7.1 Lint Filter / Loading Door
Inner Surface
Lint and fiber released from the laundry to the
air during the drying cycle are collected in the
Lint Filter.
C
Such fiber and lint are generally
formed during wearing and washing.
A
CAUTION: Always clean the lint filter
and the inner surfaces of the loading
door after each drying process.
C
You can clean the lint filter housing with
a vacuum cleaner.
To clean the lint filter:
1. Open the loading door.
2. Remove the lint filter by pulling it up and
open the lint filter.
3. Clean lint, fiber, and cotton raveling by
hand or with a soft piece of cloth.
4. Close the lint filter and place it back into
its housing.
56 / 64 EN
C
A layer can build up on the filter pores
that can cause clogging of the filter
after using the machine for a while.
Wash the lint filter with warm water
to remove the layer that builds up on
the lint filter surface. Dry the lint filter
completely before reinstalling it.
C
Clean the entire inner surface of the
loading door and loading door gasket.

7.2 Cleaning the sensors

There are dampness sensors in the machine
that detect whether the laundry is dry or not.
To clean the sensors:
1. Open the loading door of the machine.
2. Allow the machine to cool down if it is still
hot due to the drying process.
3. Wipe the metal surfaces of the sensor with
a soft cloth, dampened with vinegar and
dry them.
Dryer / User Manual