Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch psb 700 re Originalbetriebsanleitung

OBJ_BUCH-530-001.book Page 21 Wednesday, October 10, 2007 10:49 AM
If the preselected torque is reached during
screwdriving, the machine switches off; the drill-
ing tool no longer rotates. If the load on the ma-
chine is then removed with the On/Off switch 6
still pressed, the drilling tool continues to run on-
ly at very low speed for safety reasons.
After briefly releasing the On/Off switch 6, the
next screw can be driven in with the same
torque.
For screwdriving without torque lim-
itation, turn the thumbwheel 3 to the
right stop. This setting is required,
when the torque in position III is not
sufficient.

Working Advice

Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
Tips
After longer periods of working at low speed, al-
low the machine to cool down by running it for
approx. 3 minutes at maximum speed with no
load.
For drilling in tiles, set the selector switch 2 to
the "Drilling" symbol. Do not switch over to the
symbol "Impact Drilling" or work with impact un-
til after drilling through the tile.
Use carbide tipped drill bits when working in
concrete, masonry and brick wall.
For drilling in metal, use only perfectly sharp-
ened HSS drill bits (HSS=high-speed steel). The
appropriate quality is guaranteed by the Bosch
accessories program.
Twist drills from 2.5–10 mm can easily be sharp-
ened with the drill bit sharpener (see accesso-
ries).
Bosch Power Tools

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
After-sales service and customer assist-
ance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be found
under:
www.bosch-pt.com
Our customer consultants answer your questions
concerning best buy, application and adjustment
of products and accessories.
1 609 929 N03 | (10.10.07)
English | 21