Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch GSR 6-25 TE Professional Originalbetriebsanleitung

Left rotation: Push the rotational direction
switch 9 right to the stop (for unscrewing
screws).
Switching On and Off
To start the machine, press the On/Off switch 8
and keep it pressed.
To lock the pressed On/Off switch 8, press the
lock-on button 7.
To switch off the machine, release the On/Off
switch 8 or when it is locked with the lock-on
button 7, briefly press the On/Off switch 8 and
then release it.
Adjusting the Speed
The speed of the switched on power tool can be
variably adjusted, depending on how far the
On/Off switch 8 is pressed.
Light pressure on the On/Off switch 8 results in
a low rotational speed. Further pressure on the
switch results in an increase in speed.
Adjusting the Screw-in Depth (see figure B)
With the adjustment sleeve 3, the screw-in
depth of the screw head into the workpiece can
be preset in 8 locking steps per full turn. Each
step corresponds with a 0.25 mm change of the
screw-in depth.
Turning the adjustment sleeve 3 in clockwise di-
rection results in a greater screw-in depth; turn-
ing in anticlockwise direction reduces the
screw-in depth.
The required setting is best determined by test-
ing.

Working Advice

Apply the power tool to the screw only
when it is switched off. Rotating tool inserts
can slip off.
Guide the screw toward the screwdriving bit 1.
The screw is held in place by the magnet pull of
the universal bit holder 10. Firmly push the tip
of the screw into the material to be screwed un-
til the screwing-depth stop 4 faces against the
workpiece.
Bosch Power Tools
Downloaded from www.Manualslib.com manuals search engine
Switch the machine on. The screw is screwed in-
to the material until the adjusted screw-in depth
is reached. The drive is disengaged and the tool
holder no longer rotates. Check the screw-in
depth and readjust, if required.
For unscrewing screws, set the rotational direc-
tion switch 9 to left rotation and pull off the
screwing-depth stop 4 toward the front without
turning the adjustment sleeve.
Working with the screwing-depth stop 4 is also
possible when adapting the screw-in depth.
Belt Clip
With the belt clip 5, the machine can be hung
onto a belt. The user has both hands free and
the machine is always at hand.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer As-
sistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
English | 15
1 609 929 M77 | (13.5.09)