Starting Operation - Bosch gbh 24 v Professional Originalbetriebsanleitung

Removing Drilling Tools without SDS-plus
(GBH 24 VF) (see figure G)
Firmly hold the retaining ring of the quick
change keyless chuck 18. Open the quick
change keyless chuck by turning the front sleeve
in the direction of the symbol "
Remove the drilling tool.
Inserting Drilling Tools without SDS-plus
(GBH 24 V/GBH 24 VF)
Note: Do not use drilling tools without SDS-plus
for hammer drilling! Drilling tools without SDS-
plus as well as the tool holder are damaged
when used for hammer drilling.
Insert the key type drill chuck 16.
Open the key type drill chuck 16 by turning until
the tool can be inserted. Insert the tool.
Insert the chuck key
holes of the key type drill chuck 16 and clamp
the tool uniformly.
Set the selector switch 7 to the "Drilling" sym-
bol.
Removing Drilling Tools without SDS-plus
(GBH 24 V/GBH 24 VF)
Turn the sleeve of the key type drill chuck 16
with the drill chuck key in anticlockwise direc-
tion until the drilling tool can be removed.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch O-pack batteries
with the voltage given on the type plate of
your machine. The use of other batteries can
lead to injuries and danger of fire.
Set the rotational direction switch 8 to the cen-
tre position in order to avoid unintentional start-
ing. Insert the charged battery 11 into the han-
dle so that it can be felt to engage and faces
flush against the handle.
Bosch Power Tools
into the corresponding
Setting the Operating Mode
Actuate the selector switch for drill-
ing/hammer drilling 7 only when the power
tool is at a standstill.
".
Reversing the Rotational Direction
Actuate the rotational direction switch 8
only when the machine is at a standstill.
The rotational direction switch 8 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 9 actuated.
Right Rotation: For drilling and driving in
screws, push the rotational direction switch 8
left to the stop.
Left Rotation: For loosening and unscrewing
screws and nuts, press the rotational direction
switch 8 through to the right stop.
Switching On and Off
To start the machine, press the On/Off switch 9
and keep it depressed.
To switch off the machine, release the On/Off
switch 9.
For low temperatures, the machine reaches the
full hammer/impact capacity only after a certain
time.
This start-up time can be shortened by striking
the inserted tool insert against the floor one
time.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on pow-
er tool can be variably adjusted, depending on
how far the On/Off switch 9 is pressed.
Light pressure on the On/Off switch 9 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
English | 23
Hammer drilling
Set the selector switch 7 to the
"Hammer drilling" symbols.
Drilling
Set the selector switch 7 to the
"Drilling" symbol.
1 619 929 757 | (2.8.07)