Gude BIG WHEELER 560 Trike Bedienungsanleitung Seite 15

Hewed long grass lies down in the strips. Loose screw (Fig.
1/15), pull part of side ejection out and then screw. (Fig. 1/15)
tighten again (Fig. 5)
Changeover to mulching
1. Assembly and disassembly of accessories must always
take place when the engine is switched off.
2. Remove the grass catcher, insert the mulching wedge to
the ejection channel and lock the mulching wedge (1) point it
against two outlets (2) in the bottom part and ensure it with a
self-securing hook (3).
3. Please make sure the mulching wedge is mounted firmly
after the changeover.
4. Attention!!! Use original equipment from the producer
only.
5. Disassembly
Press with thumb in the middle (3) then release and deflect
the mulching wedge downwards.
Attention!!!
If the mower is blocked during mulching reduce the
travelling speed so that the knife could continue in
grinding the grass and spread it on the lawn. Never
remove the gathered grass with your hands.
DRIVE CONTROL
The self-propelling travel is controlled as follows: Press the
operation lever (lever for automatic stopping) (12) towards the
handle and simultaneously press the drive lever towards the
handle (13).
The forward movement is stopped by releasing the drive lever
(13).
CUTTING HEIGHT ADJUSTMENT
Depending on the cutting height required it is necessary to
adjust the height of wheels. Adjust the height with the lever (8)
as you wish. The middle position is most suitable at most
mowers.
ADD OIL BEFORE STARTING
The oil level needs to be checked before each use. Fill up oil
as needed (500ml SAE30 engine oil).
OIL FUNNEL CAP – OIL DIPSTICK
UPPER LIMIT
BOTTOM LIMIT
The mower is supplied without oil in the engine.
WARNING: Be careful not to overfill the engine with oil,
failing which the absorber would smoke when starting.
1. Make sure the mower stands on a flat surface.
2. Take out the oil tank cover.
3. Insert the oil dipstick and fix it.
IMPORTANT:
The oil level needs to be checked before each use. If
•
necessary, add oil to the marking on the oil dipstick.
•
The oil must be changed after 25 hours of operation or
each season. At works in a dusty or polluted environment
the oil may need to be changed more often. See " OIL
CHANGE " in the Maintenance article in these operating
instructions (SAE 30).
FUEL ADDING (unleaded petrol)
• The fuel is added through the filling hole in the tank.
Pay attention not to spill the petrol. Use common
clean unleaded petrol. Do not mix the petrol with oil.
Always buy only reasonable volume of petrol so that
you could consume it within 30 days.
WARNING: Wipe any spilled oil or petrol. Do not
store, pour, use near open fire.
FUEL TANK CAP
VERSCHLUSS DES
KRAFTSTOFFTANKS
WARNING: Alcohol-enriched fuels (gasohol) or fuels with
ethyl alcohol or methanol mixtures may attract humidity and
subsequent acid formation. The clean petrol may as a result
of long storage damage the engine fuel system. If you want
to prevent engine problems you should empty the fuel
system before storing for more than 30 days. Empty the fuel
tank, start the engine and let it run until the fuel system and
carburettor are empty. Add fresh fuel each season. See the
storing instructions, too. Never pour cleaners to the fuel tank
15