Gude BIG WHEELER 560 Trike Bedienungsanleitung Seite 14

- If you spill the petrol do not try to start the device.
o
Take the device away and prevent generation of a
flammable source around the spilled petrol.
Secure the petrol tank is closed safely.
o

Always check whether the knife, knife bolts and cutting
equipment are not damaged or worn before using the
mower. Always replace any damaged and worn knives
and bolts in the entire set to prevent device unbalance.
Do not make any alterations to the safety device.
Regularly check their proper functioning.

Keep the device clean, with no grass, leaves or other
impurities. Always wipe any oil or petrol run out. Let the
mower cool down before storing to closed spaces.

Be especially careful when changing direction on a
slope.

Never adjust the height of wheels when the engine is
running.

The grass catching device may lose its functioning any
throw away items due to wear or damage. Regularly
check the mower parts and, if necessary, replace them
with spare parts recommended by the manufacturer.

The mower knife is very sharp. Risk of injury! Be
especially careful at knife maintaining, wear protective
gloves or cover the knife-edges.

Do not change the basic engine adjustment and avoid
its overloading.

Be especially watchful when turning the mower or
pulling it towards your body.

If it is necessary to incline or lift the mower to pass a
surface other than grass or when carrying the mower to
or from the area to be cut then cut off the knife.

Release the knives and engine clutches before
switching on.

Start the engine in accordance with the operating
instructions and make sure your legs are in safe
distance from the knife.

Do not incline the mower at starting except for cases
when it is necessary. Do not incline the mower more
than necessary in such a case and always lift the part
reversed from you.

Do not start the engine when standing in front of the
ejection outlet.

Never lift and transfer the mower with engine running.

Lower the brake adjustment when the engine is off. If
the engine is equipped with a stop valve then close the
petrol supply after cutting.

Move slowly if using an auxiliary trail seat.
ASSEMBLY / PREPARATION
All assembly and/or maintenance works may be
performed only when the motor is turned off!
Please read the entire operating instructions before
assembling or starting your new mower.
IMPORTANT: The mower is supplied without oil and
petrol.
UNPACK THE MOWER
Take the mower out of the board and check whether there
are any free parts left there.
Wheel assembly (Fig. 6 a-f)
Install wheel at the lawn mower according to figures 6 a-f.
Pay attention to proper order of spacer disc at both
sides (fig. 6d)
Pay attention to that star-shaped screws are tightened
firmly enough (self-locking).
Front wheel assembly (Fig. 7-12)
Insert V shaped guide rod in the suitable fastening structure.
Guide rod secure with screws and nuts they are parts of
delivery
Assembly of collecting bag (Fig. 2) (Fig. 3) (Fig. 4)
1. Take the collecting bag, corresponding
frame and plastic insert out of the package.
(Fig. 2)
2. Put the frame into the collecting bag while
paying attention to that the coupling at the
frame is outside the collecting bag. (Fig. 3)
3. Now fix the collecting bag at the frame.
(Fig. 4)
Assembly - Handle
IMPORTANT: Disassemble the handle with care to prevent
clamping or damage of the cables.
1. Lift the handle until it snaps in the working
position.
2. Remove the protection sleeve, lift the upper parts of the
handle and assemble it with the bottom part. Tighten
the safety bolts on both sides of the handle.
3. Remove the protection sleeve of the operation grab handle in
the upper part.
Operation
Operation lever (for automatic stopping) (12) – press
the lever towards the handle when starting. If you want to
switch the engine off release the lever.
Gas lever (2) – used at starting
Drive lever (13) - used when you want the mower to be
moving forward.
loslassen = release
nach oben drücken = push up
Use
Cutting (without grass catcher)
The cut grass is laid in strips.
Cutting and collecting
The grass is collected to the grass catcher (if the grass is
damp or wet it reduces the catcher capacity). If you want to
mount the catcher to the mower lift the cover plate and hang
the grass catcher.
Mulching
When the mulching wedge is inserted (see the picture and
"Changeover to mulching" article) the grass is not thrown up
but ground by the cutting knives and the grass will remain as
surface fertilisation on the lawn
Cutting (side ejection)
14