Installation Using The Screw Holes On The Side Of The Navigation Unit - Pioneer AVIC-F30BT Installationsanleitung

Installation
Installation using the screw holes
on the side of the navigation unit
1 Remove the side brackets.
Screw for fixing the side bracket
2 Fastening the navigation unit to the
factory radio-mounting bracket.
Position the navigation unit so that its screw
holes are aligned with the screw holes of the
bracket, and tighten the screws at three or
four locations on each side.
Side bracket
(5 mm  9 mm)
If the pawl interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Dashboard or console
Engb
Section
03
23